Auto Program (Do A Channel Search) - Zenith HCS5650 Installation And Operating Manual

Auto Program (Channel Search)
Use Auto Program to automatically find and store all of the channels
available in the selected Tuning Band.
*Notes: Tuning Band must be set before doing the channel search. See Installer
menu item 003 Band/AFC. Default setting is 1, for CATV. When Auto Program is
run, any assigned channel labels are automatically cleared.
With the optional Installer remote control in hand and press
1
the POWER button to turn the TV on.
Press the MENU button and then use the ADJ
2
to highlight the Channel menu and press the OK (Enter)
button.
Press the OK (Enter) button to highlight Auto program.
3
Press the OK (Enter) button to start the channel search.
4
After finding all available channels, a display appears
briefly showing the number of analog and digital channels
found.
When finished, press MENU repeatedly to remove the menus.
5
Auto Program finds channels being received
by the TV's analog and digital tuners.
Cable will not work unless you subscribe to
a cable service.
P A G E 2 2
D or E button
--. -- ----
--:-- --
--. -- ----
--. -- ----
Antenna
Auto Program
Channel Label
Channel List
Fine Tune Auto
Signal Strength
--:-- --
D E
Move OK Select
Antenna
Auto Program
Press OK to Search
Channel Label
Channel List
Fine Tune
Signal Strength
F G
Move OK Select
Antenna
Auto Program
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
MENU Back
G
MENU Back
Yes
MENU Back