Viewing Equipment Setup - Zenith HCS5650 Installation And Operating Manual

Viewing Equipment Setup

Connect the TV/STB to the display device that will be used to view the signal.
An unswitched AC power outlet is specifically provided on the TV/STB to plug the display panel into.
LCD Display Panel Setup for use with the
TV/STB Commercial Interface Control Box.
Connect RS-232C cable. (See previous page.)
Connect IR Receiver cable to Remote In
port.
Connect the Cable Out jack to the display
panel, typically the Antenna (In) jack.
Plug the display panel AC power cord into
the convenience AC power outlet provided
on the TV/STB.
Plug the TV/STB AC power cord into a stan-
dard 120V 60 Hz power outlet.
Once power is applied to the TV/STB, the AC
power outlet is active. The LED on the dis-
play panel will turn red, indicating that the
panel is in standby mode.
Use the user-supplied remote control to turn
on the TV/STB.
Connect Aux Control IR Output
as required of your system.
P A G E 1 4
Antenna
Wall Jack
3.5mm Stereo Plug
with IR Receive
FR Coaxial Wire
(75ohm)
DVI
PILLOW INT
REMOTE
IN
1
PILLOW JACK IN AUX
(12V DC 40mA) CONTROL
HCS5650 PTC INSTALLER MENU
000 INSTALLER SEQ
UPN 000-000-000-000 FPGA E0F1
PTC V1.00.000 CPU V1.00.00
3.5mm
Stereo Plug
Audio
R - L
AC OUT 8A
AUDIO IN AUDIO OUT SERVICE
2
DIGITAL DIGITAL AUDIO DISPLAY
DIGITAL
VIDEO OUT OUT (OPTICAL) CONTROL
VIDEO IN
000
AC IN 120V~ 60Hz
AC Power
Coad