Channel List - Zenith HCS5650 Installation And Operating Manual

Channel List

After the channel search, remove unwanted channels.
Press the MENU button and then use the ADJ
1
to highlight the Channel menu and press the OK (Enter)
button.
Use the ADJ or
D
2
press the OK (Enter) button.
Use the ADJ or
3 D
to delete and press the ADJ
The ADJ G button toggles the check mark on and off.
If the check mark appears next to the channel number, the
channel appears in the channel scan.
4 When finished, press MENU repeatedly to remove the menus.
If you delete a found channel, it isn't gone forever.
Simply re-enter the Channel List menu and re-add the
channel to show the check mark.
Adding Active Channels (Before 2-5-5+Menu)
Key in active channel number.
1
Go to the Channel List.
2
Click on the right arrow to add the checkmark next to the
3
channel number.
Press MENU to exit all menus.
4
When 2-5-5+Menu is run, the channel number will be added
to the channel scan.
*Note: For broadcast channel numbers, key in the Physical channel
number and add it to the channel list.
button to highlight Channel List and
E
button to highlight the channel you wish
E
G button.
D or E button
--. -- ----
--. -- ----
Antenna
Auto Program
Channel Label
Channel List
Fine Tune Auto
Signal Strength
--:-- --
D E
Move OK Select
Antenna
Auto Program
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
D E G
Move Add/Del OK
G
MENU Back
View MENU Back
P A G E 2 3