Ansell AENLED/3M/W/ST Installation Instructions

General Installation Instructions
These instructions should be read carefully prior to any installation and retained after completion for further
reference and maintenance. Please give these instructions to the building owner/occupier after installation.
Important Safety
1. Before installation, maintenance or lamp replacement, ensure that the mains supply to the luminaire is switched off and the circuit supply fuses are removed or
the circuit breaker is turned off.
2. It is recommended that only a qualified electrical contractor carries out the installation of this luminaire and that the luminaire is installed in compliance with the
current edition of the IEE Wiring Regulations.
3. The person carrying out the installation is to check and verify that the total load on the circuit, including that of this luminaire does not exceed the rating of the
circuit cable, fuse or circuit breaker.
4. Where a luminaire incorporates discharge control gear (inductive load), the circuit capacity and ratings require careful sizing to avoid nuisance tripping of the
protective device used in the installation.
5. Where applicable, careful consideration should be taken during installation to ensure that all fixings and/or suspensions are of a suitable size for the luminaire
being installed.
Ratings
1. All luminaires are manufactured & tested in compliance with the requirement contained within BS EN 60598 and are CE marked.
2. All luminaires that are of Class 1 construction and that are marked accordingly, MUST be earthed.
3. All luminaires are designed to operate at 230Volts AC -6%/+10% = 216Volts to 252Volts. Do not operate outside these voltages.
4. All luminaires are only suitable for applications within their rated Ingress Protection limits as stated
Exclusions to Warranty
Please Note - The limited warranty shall be null and void in the following circumstances:-
Failure by the installer, end user or any third party to exercise caution to protect any covered product or part from outside
damage, adverse temperature (normal operating ambient temperature 0 - 25°C), humidity conditions, fluctuations in the
electrical system or physical abuse as well as failure related to workmanship in the installation of the products or parts.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
INSTALLATION
 Select a suitable mounting surface and provide a suitable power supply. .
 Remove the front bezel. Remove the bottom of the bezel first before gently tilting to remove
completely. Unscrew the 4x screws retaining the legends and remove all to aid installation.
 Mount the housing using either the central Besa box mounting or the 3x allocated mounting
points.
 There is a pre installed wire loop for Maintained emergency mode. Please remove this loop
for switched / non-maintained operation.
 Connect the incoming supply cable to the terminations ensuring correct polarity is observed,
please see below for electrical connections. This product has a Class I classification and
MUST be earthed.
Electrical Connection
Connect as follows:-
 Connect the battery plug to the PCB board where indicated.
 Select the desired legend, align and attach to the adhesive strips on the back plate and
attach all to the housing by replacing the 4x retaining screws
 Gently reposition the front bezel.
Note
 Switch on the mains supply. Check the unit operates correctly.
 Check the LED indicator is ON.
 The unit requires 48 hours to fully charge the battery and achieve 3 hours emergency operation.
 DO NOT deep discharge the batteries pack in emergency output for over a period of 48hrs as this will cause irreparable
damage to the battery.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page No. 1
Description – 2.6W LED Encore Exit Box Self Test
Installation Instructions
®
Luminaire Code(s) –
PERMANENT LIVE (L)
SWITCHED LIVE (L1)
EARTH
NEUTRAL (N)
www.anselluk.com
Emergency Maintained / Non-maintained
AENLED/3M/W/ST
BLACK (continuous)
BROWN (switched)
GREEN / YELLOW
BLUE
Issue Date: td 20150327