Output To The Camcorder; Time Slider - Canon 1629B001 - XH G1 Camcorder Manual

CONSOLE Windows
Playback the Recorded Files

Output to the Camcorder

By connecting the camcorder to the monitor, you can output the recorded pictures from the computer
to the monitor.
To output the playback pictures to the camcorder, you need to set the camcorder's
recording program to EXT.CONT.
When using XL H1:
If you select the HD mode, only video in HDV standard video is displayed on the monitor; if
you select the SD mode, only video in DV standard video is displayed on the monitor.
When using XL2:
Only video in DV standard is displayed on the monitor.
When the camcorder is set to HD mode and the [HD DOWN-CONV] menu under [SIGNAL
SETUP] in the [VCR/PLAY] menu is set to [ON], the playback picture will not be output to
the camcorder.
When [HD DOWN-CONV] is set to [ON] and you are unable to output the playback picture
to the camcorder, do not change the POWER dial from EXT.CONT. to any of the recording
programs. To do so, causes the error message "Another application is accessing the
camcorder." to be displayed in the software status (
reconnect the DV cable.
The camcorder's SDI terminal cannot be used for outputting pictures from CONSOLE.
When setting the camcorder to EXT.CONT. the following limitations apply to CONSOLE.
- Unable to use the special playback modes.
- The sound cannot be monitored with the computer's sound system.
- When pausing the playback, no image is displayed on the monitor.
- Unable to playback MPEG2ES picture.
- Unable to record pictures.
1
Click in the [Play Viewer] window.
• CONSOLE changes its mode to the output mode, and the camcorder will be set to the
receiving mode.
• While the camcorder is set to the receiving mode, recording cannot be performed.
2
Select a file in [File Browser] (
3
Click or double-click the selected file in [File Browser].
• The playback file is displayed in [Play Viewer] and the camcorder.
• Clicking pauses the playback. Clicking
• A few frames will not be displayed when you pause and restart the HDV standard file.
• Clicking returns the camcorder mode to the recording mode.
Various Settings and [Performance Check]
2-13). In this case, disconnect and
6-52).
restarts the playback.
Camera and Picture Control Recording onto the Hard Disk

Time Slider

• You can change the playback position by dragging the slider with the mouse.
1 Slider
2 The slider returns to the starting point.
3 The slider moves to the data dropping point after the current position.
4 Change the time slider scale.
• Data droppings that occurred during recording are indicated in red.
- By clicking , the slider moves to the next data dropping point after the current position. By
clicking , the slider moves to the previous data dropping point before the current position.
While pausing the playback picture, pressing the [] or [ ] key on the keyboard after
moving the slider with the mouse allows you to finely adjust the position of the slider.
- When adjusting the position of the playback picture of an HDV recording with the [] or
[ ] key, you cannot adjust the picture frame by frame.
Playback the Recorded Files
1 2 3
6-51
4