Canon 1629B001 - XH G1 Camcorder Manual page 33

CONSOLE Windows
Camera and Picture Control
2 [Line Select]
You can select the image-scanning mode of the waveform monitor and the vector scope.
1 Switches over between the line and full scan mode.
2 Displays the selected line number.
3 Selects a number of lines used in the line mode.
A line on the preview will be displayed in the line mode. You can drag up/down the line with the
mouse to select a scan line.
A line for
scanning
3 [Display]
You can display and hide the waveform monitor and the vector scope.
4 Waveform monitor
A waveform of the preview picture is displayed.
5 Scale
You can select the scale of the waveform monitor.
[IRE]: -40 IRE - +140 IRE
[Voltage 1]: -0.3V - +1.0V
[Voltage 2]: 0V - +1.3V
Various Settings and [Performance Check]
1 2
3
Camera and Picture Control Recording onto the Hard Disk
6 [Wave Mode]
You can select the display mode of the waveform monitor. In the PARADE mode, the waveform
monitor will be tri-partitioned.
[Composite]: Displays a luminance and color-difference signal
[Y]: Displays the luminance signal
[YUV]: Displays the luminance signal, the blue differential signal, and the red differential
signal in PARADE mode.
[RGB]: Displays RGB signals in the PARADE mode in the R, G, B order.
7 Vector scope
Displays the color information of [Rec Viewer]. Depending on the recording standards, the panel
changes automatically.
Playback the Recorded Files 4-33