Hoover U2440 Owner's Manual page 10

3-12
Remove 2 screws from bottom plate.
3-15
Lift agitator cover off.
3-18
Position new belt on agitator
brush roll
With lettering on outside of belt,
insert agitator brush roll through belt
and position belt in groove (F) on
agitator brush roll.
10
3-13
Removing hood
Lower cleaner base so it is flat on
the floor.
Remove 2 screws located at back of
hood (A). Lift hood off.
3-16
C
Grasp agitator (C) and pull up to
remove from agitator cavity.
3-19
G
F
Installing agitator brush roll
Grasp agitator brush roll firmly and
fit it into position by first sliding end
opposite the belt into the rectangular
slot (G) on side of cleaner.
Pull other side of agitator brush roll
into place.
3-14
Remove 2 screws on agitator cover
(B).
3-17
Slide belt (D) off agitator.
Remove belt from motor shaft (E).
Discard used belt.
3-20
Reposition agitator cover over
agitator. Replace 2 screws.
B
D
E