Advertisement
2-4
1
2
4
3. Maintenance
Familiarize yourself with these home
maintenance tasks as proper use
and care of your cleaner will ensure
continued cleaning effectiveness.
Filter bag
When to replace
Check the bag occasionally. When bag
is filled with dirt, the cleaner will not
operate efficiently. Discard used bag.
CAUTION: Very fine materials, such
as face powder, cornstarch, fireplace
ashes or fireplace soot may seal the
paper bag and may cause it to burst
even though it is only partially filled
with dirt. When the cleaner is used to
remove material of this nature, the
bag should be changed frequently.
Where to buy
Bags may be purchased from your local
Authorized Hoover Dealers (Depots),
Leading Retailers, Hoover Factory Service
3-2
Depress latch and lift out used bag.
Selecting tools
1. Crevice tool may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
2. Furniture nozzle may be used for
3
upholstered furniture, draperies, tapes-
try, mattresses, clothing, automobile
interiors and carpeted stairs.
3. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters and registers.
*4. Hard floor tool may be used for
walls and very irregular hard surface
floors such as brick and slate.
*Available at additional cost
Centers, or through The Hoover Company
online at www.hoovercompany.com. When
purchasing bags, be sure to give the
model number of your cleaner.
What to buy
For improved cleaning effectiveness, use
Genuine HOOVER® Allergen Filtration
Type K disposable filter bags with your
cleaner.
Regular HOOVER® Type K disposable fil-
ter bags will also fit your cleaner.
To assure that your HOOVER cleaner
operates at peak performance, it is
imperative that you use only genuine
HOOVER paper bags distributed by
The Hoover Company. HOOVER bags
can be identified by the trademarks —
3-3
To install new bag, place notches on bag
collar (at bag edge) into groove inside
lower front edge of cleaner.
2-5
Attaching tools
Attach tools to hand grip and plastic
wands by rotating latch ring until slots
align; insert tool and rotate ring to lock.
To remove tool, reverse above procedure.
3-1
Replacing the filter bag
Disconnect cleaner from electrical
outlet.
Remove cover by lifting top section of
carrying handle and pulling forward.
®
®
3-4
Pull collar forward until latch snaps into
collar. Open folds of bag. Replace cover.
5
Advertisement
