Operation; Vacuuming Dry Materials/Liquids - Craftsman 17761 - 16 Gal. Wet-Dry VAC Owner's Manual

Operation
WARNING
To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to; lighter fluid, solvent type cleaners, oil-
base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but
are not limited to; coal, magnesium, grain or gun powder. Do not vacuum
explosive dust, flammable or combustible liquids or hot ashes. Do not use this
vac as a sprayer. To reduce the risk of health hazards from vapors or dusts, do
not vacuum toxic materials.
CAUTION: To reduce risk of hearing
damage, wear ear protectors when
using the vac for extended hours or
when using it in a noisy area. The
operation of any utility vac can result
in foreign objects being blown into
the eyes, which can result in severe
eye damage. Always wear safety
goggles complying with ANSI Z87.1
or in Canada, CSA A94.3-99) shown
on Package before commencing
operation. Safety Goggles are
available at many local retail stores.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power cord into the outlet,
turn the unit on by pushing the switch from
position "O" to position "1". The symbols
used on the switch actuator are international
"On & Off" symbols. "O" is the symbol for
"OFF" and "1"is the symbol for "ON".
O= OFF I = ON
Vacuuming Dry Materials
1.The filter must always be in correct
position to reduce the risk of leaks and
possible damage to vac.
2. When using your vac to pick up very fine
dust, it will be necessary for you to
empty the drum and clean the filter at
more frequent intervals to maintain peak
vac performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your vac to pick up
dust when the filter is wet, the filter will
clog quickly and be very difficult to clean.
3. If your filter is wet but you need to use
the vac to pick up dry material, you can
quickly dry the filter by running the vac
without hose attached for about
10 minutes. The clean air rushing
through the vac will help dry the filter.
The optional Craftsman HEPA Rated
Material Filter, stock number 9-17912 will
do a better job stopping the very fine
particles than the 9-17816 filter.
Vacuuming Liquids
1. When picking up small amounts of liquid
the filter may be left in place,
2. When picking up large amounts of liquid
we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
3.After using the vac to pick up liquids, the
filter must be dried to reduce the risk of
possible mildew and damage to the filter.
4.Wben the liquid in the drum reaches a
predetermined level, the float mechanism
will rise automatic_Uy to cut off air-flow.
When this happens, turn off the vac,
unplug the power cord, and empty the
drum. You will know that the float has
risen because vac airflow ceases and the
motor noise will become higher in pitch,
due to increased motor speed.
IMPORTANT: To reduce the risk of
damage to the vac do not run motor with
float in raised position.