2.3
LED Indicators
Indicator
POWER
RS-232
100M
LINK
2.4
RJ-45 PIN Definition
RJ-45 sketch
3
Installation & Wiring
This section gives instructions on how to connect DVPEN01-SL with PLC MPU and how to connect
DVPEN01-SL to the network.
3.1
Installation
Connect PLC MPU to DVPEN01-SL
Adjust the I/O module clip on the left side of the MPU.
Meet the I/O module port of the MPU with DVPEN01-SL as shown in the figure below.
Fasten the I/O module clip on the left side of the MPU.
Connect DVPEN01-SL to other I/O modules
To connect DVPEN01-SL with the other I/O module, lift the extension clip of the I/O module by a
screwdriver and open the side cover.
DVP-PLC Operation Manual
Ethernet Communication Module DVPEN01-SL
Color
Green
Red
Orange
Green
Terminal No.
Definition
1
Tx+
2
Tx-
3
Rx+
6
Rx-
4, 5, 7, 8
-
DVP28SV
DVPEN01
POWER
RS-232
100M
LINK
RS-232
LAN
Indication
Power indication
Communication status of the series port
Network connection status
Network communication speed
Explanation
Positive pole for data transmission
Negative pole for data transmission
Positive pole for data receiving
Negative pole for data receiving
N/C
5