Dive Rite CO8200 NiTek X Quick Start Manual

175 NW Washington St.
Lake City, Fl 32055, USA
Web www.diverite.com
Phone 386.752.1087
Fax 386.755.0613
Introduction:
This Quick Start Guide will help you
get started and get you in the water
with the NiTek X. Navigating the menu
of the NiTek X is intuitive, the A (left)
and B (right) buttons are used in the
same way across all screens. Press
the A button to select, the B button to
scroll through, and the A button again
to confirm the choice.
Surface Mode:
The surface mode is the
default screen. It shows
battery power, date, time,
choice of OC or CC and
the first gas mix you will
use when diving.
PM
1-24
2:37
8:35 1:12
Fresh
Surf
To select the setpoint (SP) in CC mode
or the mix in O/C mode, hold the A
button for 3 seconds and then press the A
button again. Change the SP or mix with
the B button.
Ver. 1.0
To change the date and
time, hold down the B
button.
Quick Start Guide
Getting Started:
To wake up the NiTek X, press any button.
To return to surface mode from any other
mode, press and hold the A button.
To turn on the backlight, press the B button.
To change from OC (Open Circuit) Mode
to CC (Closed Circuit) Mode, press A and B
buttons simultaneously.
To scroll through the different menus, press A.
Cycle through the options by
PM
1-24 pressing A, make changes by
2:37
pressing B, and confirm your
2008 30
choices by pressing A again.
Time
Note:
If no buttons are pushed within
about 20 seconds, the screen will
return to its previous setting.
CO8200
NiTek X
Page 1