Ryobi RY141AM12 Quick Reference Manual

RY141AM12 QUICK REFERENCE GUIDE
WARNING:
This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual
before using this product. All page references refer to the operator's manual.
FIRST TIME ASSEMBLY
Connect the high pressure hose to the
Connect the carrying handle to the unit
1 3
trigger handle (see page 9).
(see page 9).
Connect the high pressure hose to the
4
pump (see page 9).
Connect the spray wand to the trigger
2
handle (see page 9).
5
Connect the garden hose to the pump
(see page 9).
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trig-
ger to relieve air pressure. Hold the trigger
until a steady stream of water appears.
STARTING THE UNIT
1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure
the unit is ready for operation (see page 10).
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 2 and 7).
USE ONLY THIS SIZE EXTENSION CORD
WHEN USING THIS PRODUCT:
Cord Length
NOTE: A.W.G. = American Wire Gauge
2 Press switch ON to start the motor (see page 10).
SWITCH
ON
3
When finished, press switch OFF to stop the motor (see page 10).
SWITCH
OFF
There may be residual water in the
pump due to performance testing.
Remove the spray wand. Fill soap appli-
1
cator with soap. Attach soap applicator
to trigger handle (see page 12).
Wire Size (A.W.G.)
25 ft. 14
50 ft. 12
100 ft. Not Allowed
HARD
Auto, Lawn Equipment, Boat, RV
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Always add Pump Protector to the unit after each use and before storing. This will significantly
1
improve pump life (see page 13).
Pump protector is available from your local retailer. For further assistance, call customer
service at 1-800-525-2579.
To add, follow the instructions provided by the Pump Protector manufacturer.
Make the most of your purchase! Go to www.ryobitools.com
and register your new tool online. For questions about operating or
maintaining your product please call, 1-800-525-2579.
USING DETERGENT
Squeeze trigger and wait approx. 5
2
seconds for detergent (see page 12).
NOZZLE SELECTION GUIDE
FOAMER
LOW PRESSURE
HIGH PRESSURE
(FOR SOAP OR
GENTLE RINSE)
15º 40º
25º
GENTLE
   
     
     
     
  Recommended Nozzle  Use With Caution for Certain Applications

BEFORE STORING THE UNIT
5 S
Foamer
 
 
 
 
PUMP
PROTECTOR
999000426
9-16-24 (REV:01)