Getting Started; Battery Installation - VTech 80-074400 - Nitro Jr. Notebook User Manual

WARNING:
All packing materials such as tape, plastic sheets, wire ties and tags are not part of this
toy, and should be discarded for your child's safety.

GETTING STARTED

POWER SOURCE
The Nitro Jr. Notebook ™ operates on 3 "AA" batteries (AM-3/LR6) or a VTech ® 9V
adaptor (sold separately).

BATTERY INSTALLATION

NOTE: For best performance, remove all factory-installed batteries and use new, alkaline
batteries.
1. Make sure the unit is turned OFF.
2. Locate the battery cover at the bottom of the
unit and open it.
3. Install 3 new "AA" batteries as illustrated.
4. Close the battery cover.
IMPORTANT: Please replace the batteries in about 15 seconds or you will lose any saved
information.
BATTERY NOTICE
• Install batteries correctly observing the polarity (+, -) signs to avoid leakage.
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Remove the batteries from the equipment when the unit will not be used for an
extended period of time.
• Always remove exhausted batteries from the equipment.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
• Only batteries of the same and equivalent type as recommended are to be used.
WE DO NOT RECOMMEND THE USE OF RECHARGEABLE BATTERIES.
AC-DC ADAPTOR
Use a standard 9V
9V AC/DC adaptor.
CONNECTING THE ADAPTOR
1. Make sure the unit is turned OFF.
3
300mA AC/DC adaptor. We recommend the use of a VTech
®