Advertisement
Available languages
Available languages
adjusted toanupright storage p osition
bylifting uptheredlockatthebase
oftheshaft a ndmoving t heshaft
forward, intotheupright position. The
redlockring will s nap firmly intoplace
intheupright position. SeeFigure 7 .
TURNING THE EZ=Edge=n=Store
ON
Once the unit is plugged in and you
are ready to start edging, simply push
the unit's safety trigger in with your
thumb while pulling up on the trigger
(under the handle) with your fingers.
See Figure 6. The thumb
safety
switch is only for starting
the unit
and can be released
during
edging.
To turn off the unit, release the trigger
and the safety switch wilt snap out to
prevent the trigger switch from being
accidentally depressed.
STORAGE
POSITION
The Edge-n-Store
Edger shaft can be
Fi=_ure-7
EDGING INSTRUCTIONS
AND
TECHNIQUES
*
Always keep the extension-cord
away from the area being edged.
Make sure the extension cord
is behind the edger. If you cut
or damage the cord, unplug it
immediately. AFTER the cord
is unplugged,
inspect it for
damage and repair or replace it if
necessary.
*
Maintain proper balance at all
times. Keep hands away from
blades. Wear eye protection when
using the unit. Hold the trimmer
firmly with both hands and turn
ON.
*
Do not use the edger with wet
growth
or in the rain.
CAUTION: If the edger becomes
jammed or stalled on a branch, sticks,
or foreign object, release the trigger
immediately. Failure to stop the
unit when the unit jams may cause
excessive damage to the unit's motor.
8
Advertisement
