38422XX1 39426XX1 39427XX1 Technical Specification Recommended operating pressure 45 - 80 psi Recommended hot water temperature - 140 Flow rate up to 10 gpm @ 44 psi Maximum deck thickness 1 9/16” 1 1/8" Starck Hole size for valve 1 1/4” *Know and follow all applicble local plumbing codes when setting the temperature on the water heater.
Installation Install the valves All models except Starck: Remove the plaster shields, mounting plates, o-rings, and stop rings from the valves and set them aside in a safe location. From below, insert the valves through the corresponding holes in the mounting surface. From above, slide the stop rings onto the valves.
Page 5
Install the trim Carlton/Phoenix/Terrano/Citterio: Screw the escutcheons (not included with Terrano) down over the mounting plates. Position the handle over the valve with the handle in the desired “off” position. While holding the handle steady with one hand, use the other hand to rotate the bell clockwise, so that it screws down over the valve.
Cleaning Recommendation for Hansgrohe Products Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain points when cleaning: Cleaning materials for faucets and shower products: Acids are necessary ingredients of cleaning materials for removing lime.
Page 8
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: Conditions, malfunctions or damage not resulting from defects in material or workmanship. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions.
Need help?
Do you have a question about the Axor Starck 10412 1 Series and is the answer not in the manual?
Questions and answers