Table of Contents
Advertisement
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
Chassis intrusion connector
12. Power LED connector (3-pin PLED)
This 3-pin connector is for the system power LED. The system power
LED lights up when you turn on the system power, and blinks when
the system is in sleep mode.
Power LED connector
ASUS Vintage2-PH1
CHASSIS
GND
(Default)
Chassis Signal
+5VSB_MB
PLED
PLED-
NC
PLED+
1
4-9
Hide quick links:
Advertisement
Table of Contents
