Table of Contents
Advertisement
8.
Connect the other end of the IDE ribbon cable to the Primary IDE
connector (labeled PRI_IDE) on the motherboard. See page 4-4 for the
location of this connector.
9.
Connect the other end of the audio cable to the black 4-pin connector
labeled CD on the motherboard. See page 4-7 for the location of this
connector.
10. Remove the dummy drive slot cover from the front panel.
10. Replace the front panel. Refer to section "2.11 Replacing the side
plates and front cover" on page 2-20 for details.
2-14
4
3
4
Chapter 2: Basic installation
Hide quick links:
Advertisement
Table of Contents
