Craftsman 21609 - 18 in. Scroll Saw Operator's Manual page 4

[] NEVER USEINAN EXPLOSIVE ATMOSPHERE.
Normal sparking ofthemotorcouldignitefumes.
[] INSPECT TOOL CORDS PERIODICALLY. Hf d amaged,
haverepaired by a qualified service technician at
anauthorized s ervice facility. T heconductor w ith
insulation h aving anoutersurface thatisgreen with
or withoutyellowstripesisthe equipment-ground-
ingconductor. Hf r epair o r replacement of theelectric
cordor plugis necessary, donotconnect t heequip-
ment-grounding conductor t o a liveterminal. R epair
or replace a damaged or worncordimmediately. Stay
constantly a ware ofcordlocation andkeepit wellaway
fromthe rotating blade.
[] INSPECT EXTENSION C ORDS PERIODICALLY and
replace if damaged.
[] KEEP TOOLDRY, C LEAN, A NDFREE FROMOIL
ANDGREASE. Always usea clean clothwhenclean-
ing.Never u sebrakefluids,gasoline, petroleum-based
products, o r anysolvents to clean too!.
[] STAY ALERT ANDEXERCISE C ONTROL. Watch
whatyouaredoingandusecommon sense. D onot
operate too!whenyouaretired.Donotrush.
[] DONOTUSE TOOLJFSWITCH DOES NOTTURNJT
ONANDOFF. H ave defective switches replaced byan
authorized s ervice center.
[] USEONLY CORRECT B LADES. Usethe rightblade
size, s tyle,andcuttingspeed forthematerial andthe
typeofcut. Blade teethshouldpointdowntowardthe
table.
[] BEFORE MAKING A CUT,BESURE ALLADJUST-
MENTS ARESECURE.
[] BESUREBLADE PATH JSFREE OFNAILS. I nspect
forandremove allnails fromlumber before cutting.
[] NEVER TOUCH BLADE or othermoving partsduring
use.
[] NEVER START A TOOL WHEN ANY ROTATING COM-
PONENT JS IN CONTACT WiTH THE WORKPIECE.
[] DO NOT OPERATE A TOOL WHILE UNDER THE
INFLUENCE OF DRUGS, ALCOHOL, OR ANY
MEDICATION.
[] WHEN SERWCING use only identical replacement
parts. Use of any other parts may create a hazard or
cause product damage.
[] USE ONLY RECOMMENDED ACCESSORIES listed
in this manual or addendums. Use of accessories
that are not listed may cause the risk of personal
injury. Instructions for safe use of accessories are
included with the accessory.
[] DOUBLE CHECK ALL SETUPS. Make sure blade is
tight and not making contact with saw or workpiece
before connecting to power supply.