Table of Contents
Advertisement
Quick Links
FCC ID:OU9TMB995-BS
Guangdong Transtek Medical Electronics Co., Ltd.
Zone B, No.105 ,Dongli Road, Torch Development District,
Zhongshan,528437,Guangdong,China
User Manual
Blood Pressure Monitor
Thank you very much for selecting TRANSTEK Blood Pressure Monitor
TMB-995-BS.
To use the monitor correctly and safely, please read the manual thoroughly.
Please keep well this manual in order to reference in future.
version:1.0
TMB-995-BS
Arm Type
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TRANSTEK TMB-995-BS
Summary of Contents for TRANSTEK TMB-995-BS
- Page 1 Blood Pressure Monitor TMB-995-BS Arm Type FCC ID:OU9TMB995-BS Thank you very much for selecting TRANSTEK Blood Pressure Monitor TMB-995-BS. Guangdong Transtek Medical Electronics Co., Ltd. Zone B, No.105 ,Dongli Road, Torch Development District, To use the monitor correctly and safely, please read the manual thoroughly.
-
Page 2: Table Of Contents
CATALOGUE CATALOGUE Table of Contents INTRODUCTION........................2 General Description Indications for Use Contraindications Measurement Principle Safety Information LCD Display Signal Monitor Components List BEFORE YOU START......................9 The Choice of Power Supply Installing and Replacing the Batteries Setting Date and Time Select the User MEASUREMENT.........................13 Tie the Cuff Start the Measurement... -
Page 3: Introduction
Readings taken by the TMB-995-BS are equivalent to those obtained by mine the systolic pressure and diastolic pressure as well as pulse rate. a trained observer using the cuff and stethoscope auscultation method. - Page 4 INTRODUCTION INTRODUCTION CAUTION CAUTION * This device is intended for adult use in homes only. * The ACCOMPANYING DOCUMENT shall disclose that the SPHYGMOMANOMETER was * The device is not suitable for use on neonatal patients, pregnant women,patients with clinically investigated according to the requirements of ISO 81060-2:2013. implanted, electronical devices, patients with pre-eclampsia, premature ventricular beats, atrial * To verify the calibration of the AUTOMATED SPHYGMOMANOMETER, please contact the fibrillation, peripheral, arterial disease and patients undergoing intravascular therapy or...
-
Page 5: Lcd Display Signal
* If you have any problems with this device, such as setting up, maintaining or using, please SYMBOL DESCRIPTION EXPLANATION contact the SERVICE PERSONNEL of Transtek. Don’t open or repair the device by yourself Systolic blood pressure High pressure result in the event of malfunctions. The device must only be serviced, repaired and opened by individuals at authorized sales/service centers. -
Page 6: Monitor Components
Replace the batteries whenever the below happen 1. Blood Pressure Monitor 2. Cuff (22~32cm or 22~42cm) 3. User manual shows (TMB-995-BS) (Type BF applied part) The display dims The display does not light up CAUTION Do not use new and used batteries together. -
Page 7: Setting Date And Time
BEFORE YOU START BEFORE YOU START 4.Repeat steps 2 and 3 to set the [MONTH] and [DAY]. Setting Date and Time It is important to set the clock before using your blood pressure monitor, so that a time stamp can be assigned to each record that is stored in the memory. -
Page 8: Select The User
BEFORE YOU START MEASUREMENT Tie the Cuff Select the User Remove all jewelry, such as watches and 1.When the monitor is off , press the “SET” button bracelets from your left arm. to enter user setting mode. Note: If your doctor has diagnosed you with poor circulation in your left arm, use your right arm. -
Page 9: Start The Measurement
CAUTION Interference may occur in the vicinity of equipment marked with the following symbol . And TMB-995-BS may interfering vicinity electrical equipment. Sensitive people, including pregnant women pre-eclamptic and those who implanted medical electronic instruments, should avoid using the unit whenever possible. -
Page 10: Recall The Records
DATA MANAGEMENT DATA MANAGEMENT Recall the Records Delete the Records If you did not get the correct measurement, you can delete all 1.When the monitor is off, please press “ MEM ” button to show the results of the selected user by following steps below . average value of the latest three records.If the records are less than 3 groups, 1.Hold pressing “... -
Page 11: Information For User
INFORMATION FOR USER DATA MANAGEMENT 3.Hold pressing “ SET ” button for 3 seconds when the monitor is under the Tips for Measurement memory enquiry mode(excluding the LCD displays AVG). The LCD will Measurements may be inaccurate if taken in the following display the blinking “... -
Page 12: Maintenance
INFORMATION FOR USER ABOUT BLOOD PRESSURE Maintenance What are systolic pressure and diastolic pressure? In order to get the best performance, please follow the When ventricles contract and pump blood out Systolic Diastolic of the heart, the blood pressure reaches its instructions below. -
Page 13: Why Does My Blood Pressure Fluctuate Throughout The Day
ABOUT BLOOD PRESSURE TROUBLESHOOTING This section includes a list of error messages and frequently Why does my blood asked questions for problems you may encounter with your blood pressure fluctuate pressure monitor. If the products not operating as you think it should, check here before arranging for servicing. -
Page 14: Specifications
50hPa Measurement perimeter For more information about our products, please visit www.transtek.cn.you About 22cm~32cm or 22cm~42cm of the upper arm can get customer service, usual problems and customer download, transtek Weight will serve you anytime. Approx.300g(Excluding the batteries) External dimensions Approx.102mm*143mm*73mm... -
Page 15: Complied Standards List
COMPLIED STANDARDS LIST FCC STATEMENT Complied Standards List FCC Statement EN ISO 14971:2012 / ISO 14971:2007 Medical devices - Risk management FCC ID:OU9TMB995-BS Application of risk management to medical devices This device complies with Part 15 of the FCC Rules. Operation is subject EN ISO 15223-1:2016 / ISO 15223-1:2016 Medical devices. -
Page 16: Emc Guidance
EMC GUIDANCE EMC GUIDANCE Table 2 EMC Guidance Guidance and manufacturer’s declaration – electromagnetic immunity 1)This product needs special precautions regarding EMC and needs to be installed and put into service according to the EMC information provided, The device is intended for use in the electromagnetic environment specified below. The customer or the user of the device should assure that it is used in such an environment. - Page 17 EMC GUIDANCE EMC GUIDANCE Table 3 Table 4 Guidance and manufacturer’s declaration – electromagnetic immunity Recommended separation distances between portable and mobile RF communications The device is intended for use in the electromagnetic environment specified below. The customer or the equipment and the device.
- Page 18 EMC GUIDANCE Table 5 Guidance and manufacturer’s declaration - electromagnetic immunity The device is intended for use in the electromagnetic environment specified below. The customer or the user of the device, should assure that it is used in such an environment. IMMUNITY Radiated RF Test...
Need help?
Do you have a question about the TMB-995-BS and is the answer not in the manual?
Questions and answers