Texas Instruments TI-Nspire Manual Book page 21

Stopping the Data Collection
In most data collection modes, the collection ends automatically. If using
the Events with Entry collection mode, you must stop data collection
manually. You can also end data collection for any other mode manually
at any time.
To stop a collection:
 Click
Experiment > Stop Collection.
The current run stops.
Collecting Data in the Time Based Mode
To collect data using the Time Based mode:
1. Click
Experiment > New Experiment
values.
This step removes any existing data and ensures the connected sensor
is set to its default values.
2. Connect a sensor.
Note: When you connect a sensor, the sensor name is added to the
sensor list.
3. Assign Time Based as the collection mode.
4. Click
Experiment > Start Collection
5. Click
Experiment > Stop Collection
The data set run is complete.
Collecting Data in the Events with Entry Mode
Use this procedure only after you assign Events with Entry as the
collection mode.
To collect data using the Events with Entry mode only:
1. Click
Experiment > New Experiment
values.
This step removes any existing data and ensures the connected sensor
is set to its default values.
2. Connect a sensor.
Note: When you connect a sensor, the sensor name is added to the
sensor list.
3. Assign Events with Entry Mode as the collection mode.
4. Click
Experiment > Start Collection.
to reset the sensor to its default
.
.
to reset the sensor to its default
Performing an Experiment 17