Configuring Etherchannels - Cisco WS-C2960-24LC-S Software Configuration Manual

Configuring EtherChannels

Figure 31-3
Configuring EtherChannels
These sections contain this configuration information:
•
•
•
•
•
•
Note Make sure that the ports are correctly configured. For more information, see the
Configuration Guidelines" section on page
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
Note
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
Catalyst 2960 Switch Software Configuration Guide
31-8
Load Distribution and Forwarding Methods
Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 31-9
EtherChannel Configuration Guidelines, page 31-9
Configuring Layer 2 EtherChannels, page 31-10
Configuring EtherChannel Load Balancing, page 31-12
Configuring the PAgP Learn Method and Priority, page 31-13
Configuring LACP Hot-Standby Ports, page 31-14
Chapter 31 Configuring EtherChannels and Link-State Tracking
(required)
(optional)
(optional)
(optional)
31-9.
"EtherChannel
OL-8603-04