Cisco WS-C2960-24LC-S Software Configuration Manual page 412

Displaying Port-Based Traffic Control Settings
To display traffic control information, use one or more of the privileged EXEC commands in
Table 19-4 Commands for Displaying Traffic Control Status and Configuration
Command
show interfaces [interface-id] switchport
show storm-control [interface-id] [broadcast |
multicast | unicast]
show port-security [interface interface-id]
show port-security [interface interface-id] address Displays all secure MAC addresses configured on all switch interfaces
show port-security interface interface-id vlan
Catalyst 2960 Switch Software Configuration Guide
19-18
Purpose
Displays the administrative and operational status of all switching
(nonrouting) ports or the specified port, including port blocking and
port protection settings.
Displays storm control suppression levels set on all interfaces or the
specified interface for the specified traffic type or for broadcast traffic
if no traffic type is entered.
Displays port security settings for the switch or for the specified
interface, including the maximum allowed number of secure MAC
addresses for each interface, the number of secure MAC addresses on
the interface, the number of security violations that have occurred, and
the violation mode.
or on a specified interface with aging information for each address.
Displays the number of secure MAC addresses configured per VLAN
on the specified interface.
Chapter 19 Configuring Port-Based Traffic Control
Table 19-4.
OL-8603-04