Chevrolet 2006 HHR Owner's Manual page 97

®
PASS-Key III+ to have a new key made. In an
emergency, contact Roadside Assistance.
See Roadside Assistance Program on page 7-6,
for more information.
It is possible for the PASS-Key
the transponder value of a new or replacement key.
Up to 10 keys may be programmed for the vehicle.
The following procedure is for programming additional
keys only. If all the currently programmed keys are
lost or do not operate, you must see your dealer or a
locksmith who can service PASS-Key
made and programmed to the system.
See your dealer or a locksmith who can service
®
PASS-Key III+ to get a new key blank that is cut
exactly as the ignition key that operates the system.
To program the new key do the following:
1. Verify that the new key has "+" stamped on it.
2. Insert the already programmed key in the ignition
and start the engine. If the engine will not start,
see your dealer for service.
®
III+ decoder to "learn"
®
III+ to have keys
3. After the engine has started, turn the key to LOCK,
and remove the key.
4. Insert the key to be programmed and turn it to the
RUN position within five seconds of the original key
being turned to the LOCK position.
5. The security light will turn off once the key has
been programmed.
6. Repeat Steps 1 through 5 if additional keys are to
be programmed.
If you are ever driving and the security light comes on
and stays on, you may be able to restart your engine if
you turn it off. Your PASS-Key
is not working properly and must be serviced by
your dealer. Your vehicle is not protected by the
®
PASS-Key III+ system at this time.
If you lose or damage your PASS-Key
see your dealer or a locksmith who can service
®
PASS-Key III+ to have a new key made.
®
III+ system, however,
®
III+ key,
2-19