Plustek V1.4 User Manual page 14

Chapter I
3. If you have a printer connected to your computer, please
4. Plug the SCANNER CABLE into the scanner (see Figure 1
5. Connect the other end of the SCANNER CABLE in to the PC
Attention
6. Next, plug the disconnected printer cable into the rear of the
7. After plugging the scanner and printer cables into their
8. Plug the power adapter into a standard AC outlet, see Figure 1
Danger
9. Plug in all power cords and turn on your computer.
4
disconnect its cable from the rear of the computer. If you have
more than one printer port connected to you computer, then
locate the printer port that
(EPP).
and number 1).
printer port (see Figure 1, and number 1).
Attention: If you do not have a printer connected to your
computer and are not sure where the printer port is, see
your computer
section about the printer port connector.
scanner (see Figure 1 and number 2).
respective locations, plug the power adapter into its power
receptor (see Figure 1 and number 3).
and number 4. Note: When the scanner is not in use, please
leave the power adapter connected to the AC outlet.
Only use the power adapter that is included with your
scanner (24V 550mA). The use of a different power
adapter may damage the unit and void your warranty!
the Enhanced Parallel Port
information book and locate the