CONTENTS Introduction What you'll need T he Expanse system Choosing an XP21 Mounting Location Mounting considerations Height and offset Occlusion Fixing occlusion problems Multipathing Fixing multipath problems Installing the XP21 Mounting the sensor Aligning the sensor to the intersection Cable connector...
Figure 1. Caption (sentence case) This guide will cover selecting a mounting location and installing an XP21 sensor. To find the instructions for specific tasks, see the table of contents or index. If your questions aren't answered in this guide, contact support@wavetronix.com.
■ Proximity - An important thing to consider when selecting a location is that the closer the XP21 is to the center of the inter section, the better the sensor's performance will be. ■ Clear view - Make sure the sensor has a clear view of all the approaches.
Page 23
Crimp ferrules onto the conductors. Note. If you are not using ferrules, make Remove the terminal block plugs from the Arc Surge cards in sure you carefully the back of the Arc. insert the wires and make sure all the strands are inside the spring cage.
FCC statements for Class A digital device FCC Compliance Statement Wavetronix LLC declares under our sole responsibility that the equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
ISED general statements ISED non-Interference disclaimer avetronix LLC declares under our sole responsibility that this device contains license- exempt transmitter(s) receiver(s) that comply with Innovation, Scence and Economic Development Canada;s license-exempt RSS(s). Operation is subject to the following two conditions. (1) this device may not cause harmful interference.
Need help?
Do you have a question about the XP21 and is the answer not in the manual?
Questions and answers