Download Print this page
National Instruments PXI-1020 Note To Users
National Instruments PXI-1020 Note To Users

National Instruments PXI-1020 Note To Users

In the chassis
Hide thumbs Also See for PXI-1020:

Advertisement

Quick Links

NOTE TO USERS
U
SING THE
S
C
ERIES
ONTROLLERS IN THE
Using the PXI-8150B in a PXI-1025 Chassis
Note
Before getting started, you must have an external VGA monitor. If your PXI
controller came with Windows NT, you must have access to a PC with Windows 98/95
installed to create a boot disk.
Step 1. Set the LCD Display Resolution and Mouse Routing
National Instruments™, ni.com™ and PXI™ are trademarks of National Instruments Corporation. Product and company names mentioned herein are
trademarks or trade names of their respective companies.
322603B-01
© Copyright 1999, 2000 National Instruments Corp. All rights reserved.
PXI -8150B
This document describes how to set up your PXI-8150B or PXI-8170 series
controller card in a PXI-1025 chassis.
Set the LCD display resolution on your controller to 800 × 600 by
removing a hardware jumper. Refer to Figure 1 to remove the jumper from
location W17. Set the mouse routing to internal connection by sliding the
two switches (S1 and S2) away from the front panel of the controller.
As the switches are shown in Figure 1, slide them to the right.
S1
Figure 1. Switches and Jumper Used for PXI-1025 Setup
PXI-8170
AND
PXI-1025 C
S2
W17
on a PXI-8150B Series CPU Board
HASSIS
February 2000

Advertisement

loading
Need help?

Need help?

Do you have a question about the PXI-1020 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for National Instruments PXI-1020

  • Page 1 Figure 1. Switches and Jumper Used for PXI-1025 Setup on a PXI-8150B Series CPU Board National Instruments™, ni.com™ and PXI™ are trademarks of National Instruments Corporation. Product and company names mentioned herein are trademarks or trade names of their respective companies.
  • Page 2 Step 2b. Copy BIOS Update Files to Boot Disk Copy the entire contents of the floppy disk labeled PXI-8150B Update Files for Use With a PXI-1020/1025 Chassis, which is included with your controller, to the root directory of the boot disk.
  • Page 3 800 × 600. Shut down Windows and power off your PXI-1025 chassis. Remove the VGA cable from the PXI controller. Reboot the system and verify that your LCD is working. © National Instruments Corporation Using the PXI-8150B/8170 Series in a PXI-1025 Chassis...
  • Page 4 Using the PXI-8170 Series in a PXI-1025 Chassis Step 1. Set the LCD Display Resolution and Mouse Routing As shown in Figure 2, set the following switches: Set switch S1 to set the keyboard for internal connection. Set switch S2 to set the mouse routing for internal connection. Set switch S3 to set the LCD display resolution to 600 ×...
  • Page 5 CRT is enabled. If a CRT is not connected at boot, only the LCD is enabled. Note During the initial boot process, both the LCD and CRT displays are enabled. © National Instruments Corporation Using the PXI-8150B/8170 Series in a PXI-1025 Chassis...

This manual is also suitable for:

Pxi-8170 seriesPxi-1025Pxi-8150b series