Note To Catv System Installer; Electromagnetic Compatibility Notices; Federal Communications Commission Notice; Modifications - HP 4000 - SureStore DLT 40e Tape Drive Safety And Regulatory Information Manual

Note to CATV System Installer

This reminder is provided to call the CATV systems installer's attention to section 820-93 of the
National Electric Code, which provides guidelines for proper grounding and in particular, specify that
the Coaxial cable shield shall be connected to grounding system of the building, as close to the point of
cable entry as practical.

Electromagnetic Compatibility Notices

This guide provides country- and region-specific nonwireless and wireless regulatory notices and
compliance information for the computer product. Some of these notices may not apply to your product.
One or more integrated wireless devices may be installed. In some environments, the use of wireless
devices may be restricted. Such restrictions may apply onboard airplanes, in hospitals, near explosives,
in hazardous locations, and so on. If you are uncertain of the policy that applies to the use of this
product, ask for authorization to use it before you turn it on.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is
●
connected.
Consult the dealer or an experienced radio or television technician for help.
●

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are
not expressly approved by Hewlett-Packard Company may void the user's authority to operate the
equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in
order to maintain compliance with FCC Rules and Regulations.
12 Chapter 2 Regulatory Agency Notices ENWW