Power Supply And Power Cord Set Requirements; Power Supply Class I Grounding Requirements; Denmark; Norway - HP 4000 - SureStore DLT 40e Tape Drive Safety And Regulatory Information Manual

Power Supply and Power Cord Set Requirements

Power Supply Class I Grounding Requirements

For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the
system power cord into an AC outlet that provides a grounded outlet. Substitute cords may not provide
adequate fault protection. Only use the power cord supplied with this product or a Hewlett-Packard
authorized replacement.

Denmark

For tilslutning af de øvrige ledere, se medfølgende installationsvejledning.

Norway

Apparatet må kun tilkoples jordet stikkontakt.

Sweden

Apparaten skall anslutas till jordat uttag, när den ansluts till ett nätverk.

Power Supply Requirements

The power supplies on some products have external power switches. The voltage select switch feature
on the product permits it to operate from any line voltage between 100-127 or 200-240 volts AC.
Power supplies on those products that do not have external power switches are equipped with internal
circuits that sense the incoming voltage and automatically switch to the proper voltage.
For safety reasons, use only the AC adapter provided with the unit or an authorized replacement
adapter from Hewlett-Packard. Replacement part numbers may be found at
bin/hpsupport/index.pl.

For Use in Norway

This product is also designed for an IT power system with phase-to-phase voltage 230V.

Power Cord Set Requirements

The power cord set received with the product meets the requirements for use in the country where you
purchased the equipment. Use only the power cord provided with the unit or an authorized
replacement power cord from Hewlett-Packard or an approved HP source. Replacement part numbers
may be found at http://www.hp.com/cgi-bin/hpsupport/index.pl.
Power cord sets for use in other countries must meet the requirements of the country where you use the
product. For more information on power cord set requirements, contact your authorized HP dealer,
reseller, or service provider.
WARNING!
Mismatched power cords may result in a shock and fire hazard.
4 Chapter 1 Safety Notices
Do not use power cords from other products.
http://www.hp.com/cgi-
ENWW