Placing The Tape Drive In Maintenance Mode - IBM TotalStorage Ultrium 3580 L23 Setup And Operator Manual

Placing the Tape Drive in Maintenance Mode

The 3580 Ultrium 2 Tape Drive must be in maintenance mode to run tape drive
diagnostics or maintenance procedures. To place the unit in maintenance mode:
1. Make sure that no cartridge is in the drive.
2. Make sure that the following message appears on the message display (you
3. Within 1-second interval, press the unload button 3 times. The status light
Maintenance functions cannot be performed concurrently with read or write
operations. While in maintenance mode, the 3580 Ultrium 2 Tape Drive does not
receive SCSI commands from the server.
may need to turn the power off, then on again for the message to appear):
becomes solid amber, 0 appears in the single-character display, and the
following message displays (indicating that the tape drive is in maintenance
mode):
Note: If a cartridge is in the tape drive, it will eject the first time that you press
the unload button and the drive will not be placed in maintenance
mode. To continue placing the drive in maintenance mode, perform the
preceding step.
Appendix B. Diagnostic and Maintenance Functions
61