Add Device Files - HP 157770-001 - DAT Drive 20/40 Tape Configuration Manual

5. On the Modify Kernel Module: estape page, for Next Boot State, select the "static" radio button.
Check the box entitled Backup to create a backup copy of the existing kernel (see
Figure 4 Adding
6. If you wish, type in a Reason for Change, such as "
" and then select the Modify tab.
2007
7. Click the OK button at the Operation Successful page. Both
be shown with Next Boot State as "static".
8. For autoloaders, use a similar procedure to prepare the
9. From the right-hand panel on the Kernel Configuration page, click View Pending Changes and
reboot and proceed to reboot the system as directed.
10. Following the reboot ,re-run SMH and search again for the driver as in step 3 above. Current
State and Next Boot State should both be listed as "static".

Add device files

For HP-UX 1 1i v1, 1 1i v2
Use the utility to create device files.
sam
on a system with full graphics capability, or as a console text-based interface (see
12). If you use the text-based interface, use the Tab and arrow keys to navigate, and the Return key
to select.
1. Enter
sam
% sam
2. Select the following:
Peripheral Devices
Tape Drives
will then scan the system for any tape drives connected.
sam
driver to the kernel
estape
at the command line.
HP Evolution II DDS/DAT drives: UNIX, Linux and OpenVMS configuration guide
Initial estape installation May 1st
eschgr
runs as a mouse driven GUI (see
sam
and drivers will now
estape stape
(with ) module.
schgr
Figure 1
Figure 2
Figure 4).
on page 12)
on page
15