HP 157770-001 - DAT Drive 20/40 Tape Configuration Manual page 14

2. From the SMH Tools page (see
Figure 3 SMH web-based interface (HP-UX1 1i v3)
3. In the Search box on the Kernel Configuration page, type
The search results list will include both
not installed both Current State and Next Boot State will be shown as "unused". A state of
"static" indicates that the module is installed.
4. Select the
list. From the right hand panel on the web page, click the Modify Module link.
1. The
estape
14 HP (HP-UX) servers and workstations
Figure
1
module radio button. Its details will appear in a panel below the modules
estape
and modules are linked, so it is sufficient to select the
stape
3), select Modules from the Kernel Configuration section.
stape
and modules. If either of these modules is
estape stape
and execute the search.
module alone for installation.
estape