Advertisement
Quick Links
E4 Assembly Instructions
Step 1:
Base Mounting
Place base onto shaft. Secure base to mounting surface
using two screws.
Transfer Adhesive: Peel off paper backing, place
centering tool into center hole of base, slip centering tool
onto shaft and slide base and centering tool down onto
mounting surface as one piece. Press to form a good
bond, then slip centering tool off shaft and continue with
standard mounting instructions.
Step 2:
Spacer Installation
Place spacer tool on optic module as shown below.
support@usdigital.com ▪ www.usdigital.com
Worldwide: 360.260.2468 ▪ Toll Free: 800.736.0194
Support: 360.397.9999
1400 NE 136
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
th
USD-689
2.0
Page 1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for US Digital E4
Summary of Contents for US Digital E4
- Page 1 E4 Assembly Instructions Step 1: Base Mounting Place base onto shaft. Secure base to mounting surface using two screws. Transfer Adhesive: Peel off paper backing, place centering tool into center hole of base, slip centering tool onto shaft and slide base and centering tool down onto mounting surface as one piece.
- Page 2 E4 Assembly Instructions Step 3: Codewheel Installation Slip codewheel onto shaft until it bottoms out against spacer tool. Spacer tool provides an air gap of 0.07" 0.03". Tighten set screw with either the hex wrench/hex driver while pressing down on codewheel.
Need help?
Do you have a question about the E4 and is the answer not in the manual?
Questions and answers