Advertisement
E5 Single-Ended Assembly Instructions
Please Note: These instructions apply to the E5 single-ended version only.
Step 1:
Secure base to mounting surface using two or three
screws. Slip the centering tool over shaft and into
center hole of base. Tighten mounting screws.
Remove centering tool.
Transfer Adhesive: Contact US Digital technical
support for mounting assistance.
Step 2:
Place spacer tool around shaft.
Slip hub disk assembly onto
shaft with codewheel disk
towards top until it bottoms out
against spacer tool.
Note: Alternate spacer
orientations may be required
depending on base/mounting
configuration.
Step 3:
Tighten set screw with hex
wrench provided while pressing
down on hub.
support@usdigital.com ▪ www.usdigital.com
Local: 360.260.2468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: 360.260.2469
1400 NE 136
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
th
Alternate spacer tool orientation
Hub Set Screw:
2 – 3 in-lbs torque
for G-Option base
8.0
Page 1
Advertisement
Table of Contents
Related Manuals for US Digital E5 Single-Ended
Summary of Contents for US Digital E5 Single-Ended
- Page 1 E5 Single-Ended Assembly Instructions Please Note: These instructions apply to the E5 single-ended version only. Step 1: Secure base to mounting surface using two or three screws. Slip the centering tool over shaft and into center hole of base. Tighten mounting screws.
- Page 2 E5 Single-Ended Assembly Instructions Module Screws 3.5 – 4 in-lbs torque Step 4: Slip optical module into position until the two alignment pins slip into holes of module (thick side of module towards bottom). Secure with 4- 40 x 1/2" screws (supplied).
Need help?
Do you have a question about the E5 Single-Ended and is the answer not in the manual?
Questions and answers