US Digital E4P Assembly Instructions

E4P Assembly Instructions
Step 1:
Place base over shaft. Secure base to mounting surface
using two screws. (Centering tool optional)
Transfer Adhesive: Peel off paper backing, place
centering tool into center hole of base, slip centering tool
onto shaft and slide base and centering tool down onto
mounting surface as one piece. Press to form a good
bond, then slip centering tool off shaft and continue with
standard mounting instructions.
Step 2:
Place codewheel onto shaft with pattern-side down
towards base.
Step 3:
Position spacer/installation tool onto codewheel.
Spacer/installation tool provides a nominal air gap of
0.08". Press down firmly until tool bottoms out on base
latches.
support@usdigital.com ▪ www.usdigital.com
Local: 360.260.2468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: 360.260.2469
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
E4P Assembly Instructions
v1.0
Page 1