US Digital EC35 Removal Instructions

EC35 Removal Instructions

Please Note: Due to the EC35's push-on hub design, it is recommended for use as a one-time installation.

Step 1:

To remove the EC35: unplug the cable and remove the

collet ring to free the rotation of the encoder module.

Step 2:

Rotate the encoder module until the screw access is

aligned with one of the mounting screws. Remove the

screw. Rotate the module to align the access with the

remaining screw and remove.

Step 3:

Using two flat head screwdrivers apply pressure to the

underside of each pry point, located 180° opposed at the

bottom of the mounting plate, and remove the encoder

from the motor.

*If remounting of the encoder is required continue to

steps 4 and 5 for separation of the mounting plate from

the encoder module.

support@usdigital.com ▪ www.usdigital.com

Local: 360.260.2468 ▪ Sales: 800.736.0194

Support: 360.397.9999 ▪ Fax: 360.260.2469

1400 NE 136

Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA

EC35 Removal Instructions

v3.0

Page 1

Table of Contents

Need help?

Do you have a question about the EC35 and is the answer not in the manual?

Page 1 EC35 Removal Instructions Please Note: Due to the EC35’s push-on hub design, it is recommended for use as a one-time installation. Step 1: To remove the EC35: unplug the cable and remove the collet ring to free the rotation of the encoder module. Step 2: Rotate the encoder module until the screw access is aligned with one of the mounting screws. Remove the screw. Rotate the module to align the access with the remaining screw and remove. Step 3: Using two flat head screwdrivers apply pressure to the underside of each pry point, located 180° opposed at the bottom of the mounting plate, and remove the encoder from the motor. *If remounting of the encoder is required continue to ...
Page 2 EC35 Removal Instructions Please Note: Due to the EC35’s push-on hub design, it is recommended for use as a one-time installation. *Step 4: Rotate the encoder module relative to the mounting plate and position the screw access above one pry point. Insert flat blade of screw driver between the mounting plate and module and turn 90° to pry the mounting plate and module apart. *Step 5: Pinch the sides of the encoder module and separate the mounting plate from the encoder module. support@usdigital.com ▪ www.usdigital.com EC35 Removal Instructions Local: 360.260.2468 ▪ Sales: 800.736.0194 v3.0...