Advertisement
Table of Contents
E5 Differential Assembly Instructions
Please Note: These instructions apply to the E5 differential version only.
Step 1:
Secure base to mounting surface
using two or three screws. If a
centering tool is used, slip it over
shaft and into center hole of base.
Tighten mounting screws. Remove
centering tool.
Transfer Adhesive: Peel off paper
backing, place centering tool into
center hole of base, slip centering
tool onto shaft and slide base and
centering tool down onto mounting
surface as one piece. Press to form a
good bond, then slip centering tool
off shaft and continue with standard
mounting instructions.
Step 2:
Place spacer tool around shaft as
shown. Slip hub disk assembly over
shaft with codewheel disk towards
top until it bottoms out against
spacer tool.
Step 3:
Tighten set screw with hex wrench
provided while pressing down on
hub.
support@usdigital.com ▪ www.usdigital.com
Local: 360.260.2468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: 360.260.2469
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
E5 Differential Assembly
Instructions
v3.0
Page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for US Digital E5
Summary of Contents for US Digital E5
- Page 1 E5 Differential Assembly Instructions Please Note: These instructions apply to the E5 differential version only. Step 1: Secure base to mounting surface using two or three screws. If a centering tool is used, slip it over shaft and into center hole of base.
- Page 2 E5 Differential Assembly Instructions Step 4: Remove spacer tool. Assemble module subassembly. Step 5: Slip optical module assembly into position until the two alignment pins slip into holes of module (thick side of module towards bottom). Secure with 4-40 x 1/2" screws (supplied).
- Page 3 E5 Differential Assembly Instructions Step 7: Attach cable. support@usdigital.com ▪ www.usdigital.com E5 Differential Assembly Local: 360.260.2468 ▪ Sales: 800.736.0194 Instructions Support: 360.397.9999 ▪ Fax: 360.260.2469 v3.0 1400 NE 136 Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA Page 3...
Need help?
Do you have a question about the E5 and is the answer not in the manual?
Questions and answers