Advertisement
E6 Differential Assembly Instructions
Please Note: These instructions apply to the E6 differential version only.
Step 1:
Place encoder base onto mounting surface. Slip
centering tool over the shaft and into the center
hole of base. While holding pressure on the
centering tool, tighten mounting screws. Remove
centering tool.
Step 2:
Place spacer tool around shaft. Slip hubdisk
assembly onto shaft with codewheel disk towards
top until it bottoms out against spacer tool.
Step 3:
Tighten set screw with provided hex wrench while
pressing down on hub. Remove spacer tool.
support@usdigital.com ▪ www.usdigital.com
Local: 360.260.2468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: 360.260.2469
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
Hub Set Screw:
2 – 3 in-lbs torque
2.0
Page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for US Digital E6
Summary of Contents for US Digital E6
- Page 1 E6 Differential Assembly Instructions Please Note: These instructions apply to the E6 differential version only. Step 1: Place encoder base onto mounting surface. Slip centering tool over the shaft and into the center hole of base. While holding pressure on the centering tool, tighten mounting screws.
- Page 2 E6 Differential Assembly Instructions Step 4: Press line driver onto module pins until it reaches the end of its motion. Caution! To avoid injury make sure that the line driver is held properly (as shown) during installation, module pins are sharp! Module Screws 3.5 –...
Need help?
Do you have a question about the E6 and is the answer not in the manual?
Questions and answers