Advertisement
Quick Links
Installation Instructions
Model:
Description:
Part Number:
Assembly Time: 30 Min (0.5-Hours)
It is always best practice to disconnect your negative battery terminal prior to any electronics installations to
avoid damaging the vehicle's electrical system. Before you begin, read through these instructions and check
that all parts are present.
This installation may require special skills and tools to complete and it may be necessary to seek a trained
installation technician to complete this installation. Please note that MB Quart cannot assume
any responsibility for damage resulting from incorrect installation.
No.
1
6.5" Coaxial Speaker (MBQRP-116)
2
6.5" Speaker Grill
3
Speaker Gasket
4
MB Quart Logo Badge (Not Used For Rear Speaker Install)
5
Logo Badge Retainer Clip (Not Used For Rear Speaker Install)
6
M4 x 20mm Philips Screw (Not Used For Rear Speaker Install)
7
M4 x 25mm Philips Screws
1
Philips Screw Driver
2
3mm Allen Wrench
2020-2024 Polaris RZR Pro XP, Turbo R, Pro R
MB Quart Polaris RZR Pro XP OEM Rear Speaker Replacement
MBQRP-116
Parts List
Component Name
Tools Required
Page 1 of 5
Parts List
Qty
2
2
2
2
4
8
8
Advertisement
Related Manuals for MB QUART MBQRP-116
Summary of Contents for MB QUART MBQRP-116
- Page 1 This installation may require special skills and tools to complete and it may be necessary to seek a trained installation technician to complete this installation. Please note that MB Quart cannot assume any responsibility for damage resulting from incorrect installation.
- Page 2 Disassembly ● Unlatch driver side seat. ● Remove the thumb nut. ● Release the enclosure from the bracket. ● Disconnect enclosure wiring connector. Then remove enclosure from vehicle. Page 2 of 5...
- Page 3 Disassembly ● Using a 3mm Allen wrench remove the (4) screws holding the speaker to the enclosure. ● Disconnect the speaker wire from the back of the OEM speaker. NOTE There is a release tab on the connector. ● Connect the wiring to the MB Quart speaker.
-
Page 4: Installation
Installation ● Reconnect the factory wiring to the OEM enclosure. ● Latch enclosure back into the vehicle. ● Install the Thumb screw through the bracket and into the enclosure. ● Re-install the driver seat and repeat all steps on the passenger side of the vehicle. -
Page 5: Fcc Notification
Maxxsonics, LLC. This warranty is limited to defective parts and specifically excludes any incidental or consequential damages connected therewith. To view the full warranty, please visit the website. MB Quart products are designed and engineered in the USA by www.maxxsonics.com...
Need help?
Do you have a question about the MBQRP-116 and is the answer not in the manual?
Questions and answers