VAR CD-14600 Quick Start Manual

DISC BRAKE MOUNT FACING
CD-14600
SAFETY : Facing a brake mount is a delicate opreation that requires care and attention to
details. Please refer to the frame (of fork) manufacturer's technical documentation, as well
to the technical documentation of the brake caliper mounting standard. Make sure to wear
personal protective equipment, as facing generates chips and dust that may be volatile.
EXCLUSIONS OF WARRANTY
: The
on the frame or fork material. VAR cannot be held responsible for this tool
Damages resulting
improper use.
absence of cutter lubrication...)
INSTRUCTIONS
1. Depending on the brake mount standard, install the axle in the designated slot on the tool
holder (International Standard or PostMount / Flat Mount)
2. Using a caliper, measure the frame of fork axle width to choose the correct end caps to
install on the dummy axle. Following the table above, assemble the end caps and dummy
axle on the black tool holder, then install the tool holder in the frame or fork dropouts in the
place of the wheel. Use the wheel / frame / fork skewer to secure the tool holder.
3. Depending on the brake mount standard, install the appropriate set of facing cutters.
Generally speaking, 13mm cutters are dedicated to International Standard and Front Mount,
while 20mm cutters are dedicated to PostMount and Rear Mount.
4. Release the blue knob to align the mobile cutter with the brake mount standard marker.
Tighten the knob once the cutter is in position.
5. Using a marking pen, colour the mounts to be surfaced. Once the ink is dry, apply a drop of
VAR CD-77000 cutting oil on the brake mount (except on carbon-fibre mounts that require a
drop of water).
6. Install the tool on the tool holder through the guide. It may be necessary to adjust the
mobile cutter's position.
7. Align the cutters with the brake mounts. Then secure this alignment with the tool support
black knob.
8. Hold the tool with one hand, then rotate the black knob following the arrow with your other
hand.
9. The brake mount is faced when the colouring ink has disappeared
CUTTER REPLACEMENT
1. Slide a thin flathead screwdriver between the gears to lock their rotation.
2. Using a 2.5mm hex. wrench, release the cutters' retaining screws.
3. Remove the cutters and hold the screws in place.
4. Install the cutters, taking care to align the drive squares (cutters and gears)
5. Tighten the cutters retaining screws to the stop.
6. Check for free rotation.
TOOL
disc brake mount facing tool acts
from an improper use (electric
are not covered by the VAR
EN
directly
CD-14600
driver,
warranty.
Espace Eiffel - Lot D6
19-21, Avenue Gustave Eiffel
28630 Gellainville - FRANCE
contact@vartools.com
OUTIL DE SURFAÇAGE DES
PORTÉES DE FREIN À DISQUE
+33 2 37 33 37 10
FR