Advertisement
Quick Links
EN
FORK CROWN RACE REMOVER
VAR thanks you for purchasing DR-10100 specially designed for crown race removal.
DR-10100 accepts 1" and 1-1/8" forks, and also 1-1/4" and 1.5'' tapered fork columns
(suspension or rigid) and crown races with outside diameters up to 60mm.
DR-10100 accepts steering columns from 3,5 to 32,2cm (1.38'' to 12.68'') in length when
equipped with one extension tube. Each extension tube length is 9,8cm (3.86'')
DR-10117.
The crown race remover can also be used for extracting Campagnolo/Fulcrum Ultra
Torque and Power Torque bearings.
Please read this manual carefully before each use.
The set contains
- 1 crown race remover
- 1 extra extension tube for longer fork steerers
Recommendations
DR-10100 is a precision tool that havs to be used and stored with care, avoiding
shocks, falls and mistreatments
Espace Eiffel - Lot D6
19 et 21, Avenue Gustave Ei el
28630 Gellainville - FRANCE
+33 2 37 33 37 10
contact@vartools.com
DR-10100
1/2
Advertisement
Related Manuals for VAR DR-10100
Summary of Contents for VAR DR-10100
- Page 1 Please read this manual carefully before each use. The set contains - 1 crown race remover - 1 extra extension tube for longer fork steerers Recommendations DR-10100 is a precision tool that havs to be used and stored with care, avoiding shocks, falls and mistreatments...
- Page 2 Keep on turning handles to fully remove crown race. Some forks and crown races have very little space for DR-10100 to wedge under crown race. Never over tighten tool mandrel as it may damage tool. As chamfered side of crown race is very narrow, turn handles slowly.