HOMCOM EF431K-E Manual page 5

EN
• Fix the wall bracket using that the plug and screws provided .
• Carefully lift the heater up ensuring that the two top rear slots of heater engages the
wall bracket (see Fig.3 ) and is sitting centrally.
• Gently bring the heater level with the wall.
Mark the two bottom holes position-see Fig.5, remove the heater ensuring that the
•
bottom fixing bracket is rotated up.
Drill and fit wall plug.
Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down
•
again and use the screw provided to permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the desired
•
position.
Place the front glass panel over the front of the heater aligning the hooks at each
•
side of the glass panel with the slots at each side of the heater body-See Fig.4.
Then slide down the glass panel in place. Again two people will be required for this
operation.
Insert and tighten the front glass panel screw-See Fig.6 to secure the front glass
•
panel to the heater.(Only for EF821KB,EF831K,EF851K)
EF821KB,EF831K,EF851K
4