HOMCOM EF431K-E Manual page 4

EN
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Do not operate with a damaged cord.
• Before cleaning the appliance, make sure it is unplugged from the power and that it
is completely cooled.
• Do not clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer.
It could cause danger to the user or damage to the appliance.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not lift the appliance by the front panel.
• Keep top of heater at least 1000mm away from ceiling or other objects for optimum
heat ventilation.
A.Do not use two high-power appliances in the same socket.
B.The plug needs to be plugged in fully.
C.Product socket cannot use extension cord.
The socket need to be conformed to BS1363, The maximum withstand current value
needs to be greater than 13A (Only for UK market).
Helpful Advice Before Fitting
Please retain all packaging until you have checked and counted all the parts and the
contents of the fixing pack against the parts list.
The fixing pack contains small items, which should be kept away from young children.
We suggest that you open the fixing pack and place all the contents into a container,
therefore reducing the risk of losing any small pieces.
Installation
• Do not connect the heater until properly fixed to the wall and the instructions is read
fully.
• The minimum distances must be observed.
• For installation of the heater, care must be taken not to damage concealed cables.
• Please be careful while drilling the holes.
• This appliance is designed to be permanently fixed to a wall at a minimum height of
300mm.The wall bracket must be fitted horizontally and the cable routed to the
bottom right of the heater.
• A height of 600mm from bottom of heater to floor is recommended for optimum
viewing of fuel bed(see Fig.2 for recommend fixing dimensions).
• Keep top of heater at least 1000mm away from ceiling or other objects for optimum
heat ventilation.
• For optimum viewing, mark the top five screws fixing positions on wall in
accordance with the recommend fixing dimensions- see Fig.2. Drill holes with a six
drill bit.
3