HOMCOM EF431K-E Manual page 12

EN
moment, the temperature displayed is normally set temperature, which can be
adjusted by pressing "+" or "-"
(VI) Press " TIMER SET" button to continue setting, and press "OK" complete
the setting
6. Timer switch
"TIMER ON/OFF" is to control the timed opening and closing
Restart the machine after power is cut off, the last timer setting is kept, but the current
date and time must be reset
Note 1: When the week timer is power on, you should turn on the heating function, or
else when the machine is working again, there will be only the flame effect working.
NOTE 2: Repeat the same procedures to set more timing cycles if required after the
01 timing cycle is finished.
NOTE 3: When the week timer setting is finished, "TIMER ON/OFF" function can be
effective.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats
(e.g. due to blocked air vents). For safety reasons, the fire will NOT automatically
reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and switch on the appliance.
Troubleshooting
Symptom
No operation/ no fan.
No fire effect light.
Cleaning and Maintenance
Warning- Always disconnect from the mains supply before cleaning heater.
For general cleaning use a soft clean duster - never use harsh abrasive or cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use
proprietary glass cleaners.
This product does not use a standard bulb for its flame effect. The appliance uses an
electronically controlled LED system to create the effect, therefor no parts need to be
replaced. There are no user-serviceable parts on this appliance. Under no
circumstances should the appliance be serviced be anyone other than a qualified
electrician.
Check if put the electric plug into the socket.
Check for safety cut-off operation.
Check the LED system by qualified electrician.
11
Solution