Table of Contents
Advertisement
5.SCSI Interface
The TRANSFER WIDTH EXPONENT field defines the transfer width to be used during DATA IN phases, and DATA
OUT phases. The transfer width that is established applies to both SCSI devices. Valid transfer widths are 8 bits
(m=00h) and 16 bits (m=01h) if all the protocol options bits are zero. The only valid transfer width is 16 bits (m=01h)
if any of the protocol options bits are one.
QAS_REQ bit is not supported and shall be set to zero.
IU_REQ bit is not supported and shall be set to zero.
DT_REQ bit of zero indicates that DT DATA phases are to be disabled when received from the initiator and that DT
DATA phases are disabled when received from the target. A DT_REQ bit of one indicates that DT DATA phases are
to be enabled when received from the initiator and that DT DATA phases are enabled when received from the target.
A data transfer agreement only applies to the two SCSI devices that negotiate the agreement. Separate data transfer
agreements are negotiated for each pair of SCSI devices. The data transfer agreement only applies to DATA
phases.
A PARALLEL PROTOCOL REQUEST message exchange shall be initiated by an initiator whenever a previously
arranged parallel protocol agreement may have become invalid. The agreement becomes invalid after any condition
that may leave the parallel protocol agreement in an indeterminate state such as:
a) After a hard reset
b) After a TARGET RESET message
c) After a power cycle
d) After a change in the transceiver mode (e.g., LVD mode to SE mode)
5.3.2.2.
SYNCHRONOUS DATA TRANSFER REQUEST (01h)
This is sent by either the initiator or the target as the first byte of a multiple-byte message. When acting as an initiator,
the unit will not send any Extended Messages. No Vendor Unique codes are implemented and only the Synchronous
Data Transfer Request code is supported. Any other message code is handled as an illegal message; the unit will
return MESSAGE REJECT and will continue. A Synchronous Data Transfer Request message has the following
format:
Byte
Value
0
01h
1
03h
2
01h
3
M
4
X
A SYNCHRONOUS DATA TRANSFER REQUEST (SDTR) message exchange shall be initiated by a SCSI device
whenever a previously-arranged data transfer agreement may have become invalid. The agreement becomes
invalid after any condition which may leave the data transfer agreement in an indeterminate state such as:
(1) after a hard reset condition
(2) after a BUS DEVICE RESET message and
(3) after a power cycle.
In addition, a SCSI device may initiate an SDTR message exchange whenever it is appropriate to negotiate a new
data transfer agreement (either synchronous or asynchronous). SCSI devices that are capable of synchronous data
transfers shall not respond to an SDTR message with a MESSAGE REJECT message.
The SDTR message exchange establishes the permissible transfer periods and the REQ/ACK offsets for all logical
units and target routines on the two devices. This agreement only applies to data phases. The transfer period factor
times four is the value of the transfer period.
Transfer period is the minimum time allowed between leading edges of successive REQ pulses and of successive
ACK pulses. The SDX-800V supports the following transfer periods:
5-6
Table 5-3: Synchronous Data Transfer Request
Extended message
Extended message length
SYNCHRONOUS DATA TRANSFER REQUEST code
Transfer period (m times 4 nanoseconds)
REQ/ACK offset
Description
SONY AIT-3Ex drive SDX-800V series Ver.1.0
Advertisement
Table of Contents
