Table of Contents
Advertisement
6.Command Specification
Media Type: The media value will be ZERO as only one media type is supported.
WP: A Write Protected bit of ZERO indicates that the tape is write enabled. A Write Protected bit of one indicates that
the tape is write protected.
Buffered Mode: if this bit is set to ZERO, the drive will not report a GOOD status on WRITE commands until the data
blocks are actually written on the tape. If set, the drive is in buffered mode and may report a GOOD status on WRITE
commands as soon as the data block has been transferred to the drive's buffer. One or more blocks may be buffered
prior to writing to the tape. (Not support)
If the Buffered Mode field is ONE, then drive reports GOOD status on WRITE commands as soon as the data block
has been transferred to the buffer, this field should be set to ONE.
Speed Field: will return ZERO as the drive only supports one speed.
Block Descriptor Length: returns a value of 8, which specifies the length in bytes of the following Block Descriptor.
The drive only returns a single Block Descriptor.
Density Code: The drive returns 30h, 31h, 32h, and 3Bh in the Density Code field.
Number of Blocks: The Number of Blocks field is ZERO, indicating that an unspecified (or unknown) number of the
remaining logical blocks on the tape may have the media characteristics specified by the Block Descriptor.
Block Length: The Block Length field specifies the length in bytes of each logical block transferred over the SCSI
bus. A Block Length of ZERO indicates that the length is variable. Any other value indicates the number of bytes per
block that the drive must handshake over the bus. This establishes Block Length such that the Transfer Length for
read, write command will be a block count not a byte count. Minimum Block Length is 2. If Block Length is 1, the
drive will return the CHECK CONDITION status with an ILLEGAL REQUEST sense key.
Note: It is value of this field together with the Fixed Bit Field in the READ, or WRITE commands that determine
whether the drive is in Fixed or Variable block mode. The minimum length is 4 and it always should be a multiple of
4.
Page Descriptor: The supported pages are fully documented in the MODE SELECT clause of this Chapter.
PS: When the Page Savable bit is set, this indicates that the page contains saved parameters. This bit will never be
set as there is no non-volatile RAM on the drive into which parameter data may be saved.
All fields not supported by the drive must be set to ZEROs.
6.8.1. Mode Sense 31h (AIT Device Configuration Page)
Note 1: SDX-800V always reports the status of the cassette present in the drive, even if the mode values are
changed.
Note 2: AIT-bit and DEV-bit values are changed after completing the Mode Select Page 11h.
Note 3: SDX-800V reports the following status for a virgin cassette:
6-58
Bits
SDX-T3N
AIT
0
DEV
0
ULPBOT
1
PRTH
0
PONEJ
0
ABS
0
MIC
0
SysLogAlive
00B
MIC Cartridge
0
0
1
0
0
1
1
11B
SONY AIT-3Ex drive SDX-800V series Ver.1.0
MODE SENSE
Advertisement
Table of Contents
