Eastwood 14150 Instructions

4. Hold the trigger to activate the arc and count to the appropriate time. Adjust the time accord-
ingly after trying on test panels.
5. Release the trigger to stop the arc and pull back the torch to reveal the spot weld. If possible
make sure that the spot weld fully penetrated before continuing on.
6. Continue on to finish all of the predetermined spots for the welds. It is beneficial to move
around when welding rather than doing the spot welds all consecutively as it could overheat the
panel and causing warping.
TROUBLESHOOTING
• THE WELD DID NOT PENETRATE TO THE REAR PANEL
- Turn up the Amp setting.
- Allow for a longer arc time.
- Assure spot weld pliers are achieving a secure clamping force.
- Make sure the metal is clean. The use of a flap disc on all contact surfaces being
welded is highly recommended.
-
• THE WELD BEAD IS TOO LARGE IN DIAMETER
- Decrease time of welding. Be sure not the decrease the time too much which could
cause poor penetration.
OPTIONAL ACCESSORIES
#31018
Flanger and Hole Punch Combination Tool
#31015 Pneumatic Flanger and Hole Punch Combination Tool
#19017
Spot Weld Drill 3/8"
#19003 Spot Weld Drill 1/2"
#14150A TIG Spot Weld Nozzle (2 Pack)
#13899
Spot Weld Pliers
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
800.343.9353 eastwood.com
© Copyright 2019 Easthill Group, Inc. 1/19 Instruction item #14150Q Rev 1
TIG SPOT WELDING KIT
INSTRUCTIONS
Part #14150