Summary of Contents for Savaria PREMIER LIFTS Eclipse
Page 2
10927 McCormick Rd. Hunt Valley, MD 21031 Elevator Basics Should you have any issues with your elevator please feel free to call our office at 410- 561-7006, ext. 205 for service or 800-688-6116. Your elevator comes with a limited factory parts warranty of 3 years.
Page 3
tab and open the door normally. Close the accordion gate as you exit and then close the hoistway door. It may be possible that the lift will need to be reset at this time. To Reset the Elevator First, you can always call our number and speak to one of our representatives for help with resetting the elevator.
Page 4
3. Inside the box on the right side there is a digital read out. Red letter/numbers. If the display reads “h66” there is a safety open somewhere. Typically, this means you have a door or a gate not closed properly or not functioning properly. If you are confident that the doors and gate is closed, you will likely need to call in for service.
Page 5
This Warranty supersedes all other published warranties in Owner’s and Installation Manuals and applies to sales after November 14, 2005. *For the Savaria S64, C65 and Roby, the warranty period is limited to 24 months. For Quebec projects with the S.H.Q / P.A.D program , S.A.A.Q and C.S.S.T , the warranty terms shall be the same limited warranty but for a period of 12 months.
Page 6
Eclipse Residential Elevator (with Micro-6 Controller) OWNER’S MANUAL (To Be Retained by Owner After Installation by Authorized Savaria Dealer) Part No. 000841 29-m08-2018...
IMPORTANT Ensure that only an Authorized Savaria Dealer installs and services the Savaria™ Eclipse Residential Elevator. Under no circumstances is anyone other than a dealer with Savaria training and authorization to install, adjust, service or modify any mechanical or electrical device on this equipment. Failure to follow this warning can result in safety system compromises or defeat;...
Ensure that only qualified personnel perform maintenance and service on the unit. • When replacing parts, be sure that only genuine Savaria parts are used. • This unit is intended for use by a mature person who understands its proper operation as set out in this manual.
1. SPECIFICATIONS Eclipse Specifications Load capacity 750 lb (341 kg), 950 lb (432 kg), 1000 lb (454 kg) Rated speed 40 ft/min (0.2 m/s) nominal Maximum travel 50 ft (15.24 m); 60 ft (18.3 m) available where code is not applicable Maximum # of stops 6 stops Normal: 40...
Page 11
Eclipse Specifications (continued) Cab gate safety switch Main controller cab wall access safety switches Pit run/stop switch and car run/stop switch Emergency stop and alarm buttons Uninterruptable power supply (UPS) battery back-up system for lowering, automatic gate operation (if equipped) and electrical interlock operation and lighting in the event of a power failure...
2. FEATURES 1 Cab Key Switch (Figure 1-A) Figure 1: Sample COP The key switch turns the cab controls ON and OFF. It is provided to limit the use of the elevator to authorized persons only. 2 Cab Operating Panel Buttons (Figure 1-B) Automatic control panel buttons facilitate the UP/DOWN movement of the cab between landings.
Page 13
6 Handrail A single handrail is mounted on the Cab Operating Panel side of the cab. 7 Emergency light The cab emergency light remains ON in the event of a main power failure. The emergency light uses a battery back-up system. 8 Landing Hall Call Station Controls (Figure 3) Figure 3: Hall Call Hall Call buttons are installed at all landings to move...
3. OPTIONS Automatic Door Opener 1 Press the Landing Hall Call button to call the elevator. The entrance door will open automatically once the elevator stops at the landing. 2 Push N Go allows the entrance door to open automatically with a slight push to the door itself.
4. OPERATION Operating from the Landing Controls 1 If equipped with a key switch, insert the key into the key switch on the Hall Call station and turn the key to the ON position. 2 Press the Hall Call button once and release. The elevator will automatically come to your landing.
Operating from the Cab Operating Panel (COP) Controls 1 If equipped with a key switch, insert the key into the key switch on the Cab Operating Panel and turn the key to the ON position. 2 Press the selected Landing button once and release. The elevator will automatically travel to and stop at the selected landing.
6. EMERGENCY LIGHTING In the event of a main power failure, the emergency COP light will turn on automatically. NOTE If one of the cab ceiling lights burns out, replace the bulb with a 10W bulb ONLY. 7. MANUAL LOWERING In the event of a power failure, the UPS lowers the cab to the next landing and opens the doors.
All beep codes that begin with a long beep (on for 2 seconds) are Service codes (contact your authorized Savaria dealer). If you press a Hall Call button and it beeps but the car doesn’t move, refer to the information in the following table....
9. MAINTENANCE Regular maintenance (performed by your Authorized Savaria Dealer) will keep your elevator in proper operating condition. Please remember, as the owner of this elevator, you are responsible for making sure that maintenance and upkeep are done on a regularly scheduled basis.
Maintenance Record Date Time Reason for Call Comments Dealer Part No. 000841, 29-m08-2018 Eclipse (Micro-6) Owner’s Manual...
Page 21
410-561-7006 Eclipse (with Micro-6 Controller) OWNER’S MANUAL Part No. 000841 Copyright 2018 Savaria Concord Lifts, Inc. 2 Walker Drive Brampton, Ontario, L6T 5E1, Canada www.savaria.com For service or questions about this product, please contact your installing dealer. Premier Lifts DEALER NAME:...
Need help?
Do you have a question about the PREMIER LIFTS Eclipse and is the answer not in the manual?
Questions and answers