Remote Control - Yamaha RX-A1000 Owner's Manual

Remote control

Problem Cause
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
The batteries are weak.
The remote control ID of the
remote control and this unit do not
match.
The battery of The power of battery is not
remote control runs
enough.
out immediately.
External components The remote control code is not
cannot be controlled
correctly set.
using the remote
control.
Even if the remote control code is
correctly set, there are some
models that do not respond to the
remote control.
See
Remedy
page
The remote control will function within a —
maximum range of 20 ft. (6 m), and no
more than 30 degrees off-axis from the front
panel.
Adjust the lighting angle, or reposition this —
unit.
Replace all batteries. 13
Match the remote control ID of this unit and 125,
the remote control. 129
Replace the battery with alkaline battery. —
Set the remote control code correctly using —
"Remote control code search" on the CD-
ROM.
Try setting another code for the same —
manufacturer using "Remote control code
search" on the CD-ROM.
If this unit does not work when you press —
Cursor B / C / D / E, do the following.
When the key does not work during DVD
disc menu operation: press the Input
selector again.
When there is no response with remote
control operation of the Option menu/Setup
menu: press SOURCE/RECEIVER (it
should glow orange) and try operating the
remote control again.
—
APPENDIX
Troubleshooting
147
En