These instructions are intended for qualified personnel who are 1. Notes on documentation familiar with the assembly, installation and operation of the ISYGLT system. It is essential that you read these operating instructions through before commissioning and keep them accessible for 1.1.
Only use original spare parts and additio- type. For applications with a higher required IP protection type, nal equipment from the manufacturer. the ISYGLT module must be installed in a housing or a cabinet 2.7. Liability notes with a higher IP protection type.
These are limited to the intended use of the module and refer EU on waste electrical and electronic equipment at the local collec- to the repair or replacement of the ISYGLT module. Please send the tion points for waste electrical and electronic equipment! device with an attached error description to our company address given below.
9. Product description The DALI-16B-2X module is used to control electronic ballasts for LEDs that communicate with the DALI protocol. Up to 64 DALI ECGs (elec- tronic ballasts) can be operated on each of the two DALI lines. Each of these 64 DALI participants must be programmed with a unique device address (DALI short address).
DIP switch • 8-pole DIP switch for setting the ISYGLT BUS address (0-127) is located under the cover of the module. Special function DIP switch 1 - S1 OFF: Normal operation - S1 ON: Emergency / test operation with button on the module (ON / OFF)
View 11. Wiring diagram 230V 50Hz +24V BUS-A BUS-B 230V ! 1 2 3 4 5 6 7 8 BUS address ISYGLT-DALI-16B-2X Art. no.: 80027165 DSI BUS or DSI BUS or DALI BUS DALI BUS Continuous voltage! Max. 64 ECG/output Misprints and technical changes reserved.
Need help?
Do you have a question about the DALI-16B-2X and is the answer not in the manual?
Questions and answers