Yamaha Clavinova CVP-307 Owner's Manual page 208

Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the selec-
tor for 110V, 127V, 220V or 240V main voltages, use a "minus"
screwdriver to rotate the selector dial so that the correct voltage
for your region appears next to the pointer on the panel. The volt-
age selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC
power cord to the AC INLET and an AC wall outlet. A plug adap-
tor may be also provided in some areas to match the pin config-
uration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the Clavinova or result in improper operation.
6
Set the adjuster.
Rotate the adjuster until it comes in firm contact with
the floor surface.
7
Install the Floppy Disk Drive.
Connect the USB cable to the [USB TO DEVICE] ter-
minal.
208 CVP-309/307 Owner's Manual
■ After completing the assembly, please check
the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any
errors.
• Is the Clavinova clear of doors and other movable
fixtures?
→ Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
→ Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal and power cords inserted securely
into the sockets?
→ Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the assem-
bly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper han-
dling can result in damage to the instrument or personal
injury.
Key cover
Do not hold here.
Top portion
Do not hold here.